How To Install Micro Sd Card In Galaxy S3

Introduction

Use this guide to supersede the microSD bill of fare.

The following four steps can be accomplished without a plastic opening tool. However, it's recommended to use a tool to best avoid breaking any clips along the perimeter of the rear case.

The following four steps tin can be accomplished without a plastic opening tool. However, it's recommended to employ a tool to all-time avert breaking any clips along the perimeter of the rear case.
Insert a plastic opening tool or fingernail into the notch in the gap between the rear case and the residuum of the phone, located at the top of the device.
Gently twist the opening tool to disconnect the clips securing the summit of the rear instance.

Slide the plastic opening tool left along the top edge and repeat the twisting motion to widen the gap between the rear case and the phone.

Slide the plastic opening tool left forth the superlative edge and echo the twisting motion to widen the gap between the rear case and the phone.

Continue to move the plastic opening tool effectually the perimeter of the peak left corner, gently prying up along the rear instance.

Pry along the top right side, and continue prying down the right side of the rear case.

Elevator up and remove the rear case from the telephone.
You may need to peel the case upwards to separate it from any clips yet belongings it to the bottom of the phone.

This stride can be accomplished without the need of a plastic opening tool. Just use your finger if you desire to.
Wedge a plastic opening tool into the small-scale notch in a higher place the battery.
Pry the battery up out of its recess.

Remove the battery.

Using your fingernail, button the microSD card slightly deeper into its slot, until you hear a click.
After the click, release the card and information technology volition pop out of its slot.
For reassembly, push the microSD card into the slot until it clicks in place.